PREFORMED INSULATING PANEL
Description:
Preformed insulating panel for underfloor heating made of EPS.
Complies with EN-1264 standard for installation on heated premises.
Suitable for pipes from 16 to 18 mm in diameter, installation in multiples of 75mm.
Connection between panels by interlocking.
Surface area 1.215m².
Dimensions: 1350 x 900 x 23mm.
Technical Data:
- Usable pipe diameter: Ø 16÷18 mm
- Installation pitch: multiples of 75 mm
- Flexural strength (KPa): ≥ 150
- Compression stress (σ10) – (KPa): ≥ 100
- Permanent compression creep (KPa): CC(2/1.5/50)30
- Tensile strength (KPa): ≥ 200
- Density: 22 kg/m³
- Water absorption (%): ≤ 1
- Water vapor permeability (δ) (mg/Pa·h·m): 0.009 – 0.02
- Fire reaction: EUROCLASS E
Storage Conditions:
- Panels should not be exposed to direct sunlight
- Thermal storage conditions should be between 5°C and 50°C
- Panels should not come into contact with chemical agents
- Keep panels away from flames, sparks, welding drips, or any heat source.
Warning:
Keep the product dry and protected from sunlight before, during, and after installation, until it is covered by the mortar.
Notes:
- Usable pipe diameter: Refers to the range of pipe diameters that the panel is designed to accommodate.
- Installation pitch: Refers to the spacing between pipes when they are installed on the panel.
- Flexural strength: Measures the panel’s ability to resist bending.
- Compression stress: Measures the panel’s ability to withstand compressive forces.
- Permanent compression creep: Measures the panel’s long-term deformation under sustained compressive load.
- Tensile strength: Measures the panel’s ability to resist being pulled apart.
- Density: This is a measure of the panel’s mass per unit volume.
- Water absorption: Measures the amount of water the panel can absorb.
- Water vapour permeability: This measures the amount of water vapour that can pass through the panel.